How to maintain or modify a door Clopay Garage

!±8± How to maintain or modify a door Clopay Garage

Set the Clopay garage door can be a difficult task. This article shows how to change your door with precision and safety.

First of all, closed the work in the garage with the door all the way home. You do not want to accidentally shut the door on you or someone in the workplace. Check the traces of metal for everything, really smooth spots or itching. If you see every minute of injury flatten it with the rubber mallet favorites. Strongly deformed must check the points to be replacedThe kits, which provide the track position. If you see a loosening of the mounting bracket, then tighten the bolts and screws to stabilize in place.

Make sure that the securities are properly aligned with a plane. Tracking should be vertically aligned specifically full or close to the same height on the wall of the garage. If you see no traces aligned to the right, loosen the screws of the bracket, but there is no need to pull it off completely. For the horizontal distance shouldTilted slightly downward toward the rear of the garage. Something hit the tracks in the correct position with a hard rubber mallet. Always use a level to double the correct orientation before any tightening of the screws or bolts that need it.

Use a spray lubricant of choice or that, the manufacturer of lubricating oil on, drive rollers and roller tracks.

If you see a big hole screw, replace the screw with a longer screw. If you have a suspension forHinges, to correct this. Check if they are damaged or do not tighten the screws.

Experiment with the electric eyes on both sides of the door frame. They need each other, or may face operational problems. Try the door without opening the device. If the port is operating properly without opening the problem is with the unit and not opening the door itself means. Then, close the garage door. Lower limit of the race when the door is closed and returns immediately. If the door starts to move to anotherStreet, without disturbing anything, then optimize the clamping force. By changing these two factors, a major change in the operation.

Check the springs. Springs for the back-end lay the tracks. Torsion springs are on top. Do not forget, you can repair a professional installer to contact a garage door torsion spring, as they break and cause serious damage to unlucky "DIY". Use the instructions at the gate of voltage required for each spring. They differ inDoor.